The servo part I have working as I triggered it from a digital button. That was a garage door opener which needed a switch to detect the doors status and an output that drove a relay (called a relay in tasmota).Īs the switch in my system was actually a switch that stayed open or stayed closed depending on the state of the door I didn't think too much into it at the time.īut now I'm looking at an esp8266 that on button press, tells the pwm pin to rotate a servo motor to an angle and then back again. However only one device has been a esp8266. ![]() In the past I used tasmota on a power plug or two. ![]() I don't see how another device could have the same IP or MAC and I don't understand how I could modify the DNI before the device has been added to the system. I think I have installed and configured T4HE correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |